Skip to main content

WM Painting and Decorating

Heritage House Painters in Wollongong and the Southern Highlands

Federation cottages, Victorian terraces and inter-war bungalows were built to last, and they need a different approach to a modern project home. As heritage house painters in Wollongong and the Southern Highlands, we repair first, prepare carefully and choose coatings that suit old timber and masonry. Our Wollongong painters page lists the areas we cover.

Licensed & Insured

Fully licensed and insured painters with 10+ years in the trade.

Prep Comes First

Cracks, salts and failed paint are dealt with before any coating goes on.

Coastal Conditions

Systems chosen for salt air and Illawarra humidity.

Free Quotes

A site inspection and a free, no-obligation quote.

HERITAGE AND RESTORATION

Painting Period Homes Properly

An older house has layers: decades of paint, patched timber and masonry that moves with the seasons. Good heritage work respects those layers and does not bury them.

Colour Consultation

Choosing colours for a period home? We can help you work out a scheme that suits the era and the street.

Heritage Painters for Illawarra and Highlands Homes

Older homes in Berrima, Bowral, Kiama and Bulli come in many styles, from Federation and Victorian to inter-war. Each one has its own materials and its own problems, and a colour or product that suits one house can harm another.

WM Painting & Decorating is licensed and insured, with 10+ years in the trade. We look at what the house is made of before we quote, then match the repair and the coating to it. Our exterior painting and timber, weatherboard, deck and fence painting services cover the general side of this work, and render and brick painting covers masonry. For colour decisions, start with our colour consultation service.

What you can expect from us:

Heritage Painting by Surface

Older houses fail in particular ways. These are the surfaces we are asked about most.

Soft or split timber is repaired or replaced where needed, old paint is taken back to a sound edge, and bare patches are primed before the topcoat. Putty, sashes and sills get close attention because water gets in there first.

Old masonry needs to let moisture out. We check for salts, damp and loose render, repair what is failing and choose breathable coatings rather than sealing the wall.

Cast iron, steel and decorative fretwork are cleaned back, rust is treated and the surface is primed before painting. Fine detail is brushed so it stays crisp.

Lath and plaster, timber panelling and decorative ceilings need gentle preparation and the right fillers. Our interior painting page covers the general process.

Painter carefully adding a soft neutral coat to a home's exterior, balancing light wall colors with darker accents on gutters and trims to create contrast and highlight architectural features.

Heritage Painting: Straight Answers

Does my home have heritage restrictions?

Some older homes are heritage items, and others sit inside a conservation area. Wingecarribee Shire Council’s heritage page explains that local heritage is managed through its Local Environmental Plan, which lists heritage items and conservation areas, and that a planning certificate states whether a property is an item or in a conservation area. The council adds that a listing does not stop a property changing, but changes must be carefully considered so they do not harm its heritage significance.

Other councils, including Wollongong and Kiama, run their own heritage controls, so the rules differ by address. Check with your council before you choose a colour scheme or change a material. Repainting a surface that was always painted can be treated differently from painting bare brick or stone, so ask what applies to you. We can describe the work in writing to support that conversation.

Lead paint in older homes

Lead paint was used in most Australian homes built before 1970. The NSW Government’s LeadSmart renovating and maintenance guidance says it can be hazardous even before work starts, for example when it chips around windows and doors, and that renovation raises the risk when old paint is removed from walls. If the paint is in good condition, its advice is to leave it alone or paint over it.

Where old paint has to come off, the guidance points to wet sanding and wet scraping, no open-flame torches, sealing off the work area, a fitted P1 or P2 respirator, and wet cleaning or a HEPA vacuum rather than sweeping. Those are the habits we build into preparation on pre-1970 homes. The guidance also says to keep pregnant women, breastfeeding women and young children away from the work, so tell us who lives in the house before we start.

Breathable paint for old masonry

Old brick, stone and lime render take in and release moisture. The Heritage Council of NSW limewash information sheet explains that old walls can contain salts that attract water in humid weather, and that they should never be coated with water repellents or other products meant to seal them, because the coating traps moisture and causes damage.

The sheet also warns that many commercial paints sold as limewash contain materials like modern acrylic paints and do not breathe like the traditional product. On old masonry we confirm what is on the wall now, then choose a coating that suits it, and we tell you straight if a finish needs a specialist lime product. Our render and brick painting page explains how we treat salts and damp on other masonry.

Traditional colour schemes

A period house usually looks best in colours that belong to its era. Federation homes often pair a muted body colour with contrasting trims, fretwork and a deeper accent on the door, while inter-war homes lean towards simpler schemes with softer accents. A council heritage adviser or a paint maker’s heritage range is a good place to start.

Original colours can sometimes be found by looking under later paint layers in a spot out of the weather. Old layers may contain lead, so do that wet and carefully, or ask us to do it. We can then put sample patches on the wall to see the colours in the house’s own light.

Timber repairs before paint

Paint cannot fix rot. On verandahs, weatherboards and sills we probe for soft timber, cut out what has failed and repair it with timber or a suitable filler, depending on the extent. Joints are sealed, bare timber is primed, and the topcoat goes on only when the surface is dry.

Where a carpenter is needed for major replacement, we say so at the quote stage rather than paint over the problem. Homes in the Highlands villages around Berrima and Bowral often have timber that has weathered through cold winters, so this step is worth the time.

Our Simple Process

How We Work

01

Free Quote

Tell us about the house, its age and any heritage listing, and we will arrange a free quote.

02

Consultation

We inspect timber, masonry and existing paint, and talk through colours and any council requirements.

03

Preparation

Repairs come first, with lead-aware preparation and breathable systems chosen to suit each surface.

04

Professional Painting

Primers and coatings go on in the order the manufacturer specifies.

05

Final Inspection

We walk the finished house with you before we pack up.

Our Work

Our Painting Work

Restoring an Older Home?

Call 0434 432 267 or send us a message for a free quote on heritage and restoration painting in Wollongong, Kiama and the Southern Highlands.

FAQ

Frequent Answer Questions

It depends on the council and the listing. Some councils want colour schemes checked for heritage items and conservation areas. Check with your council before you choose colours, and we can write up the scope to support that conversation.

Possibly. NSW LeadSmart guidance says lead paint was used in most Australian homes built before 1970. We use lead-aware preparation methods on older homes and can talk through your options before work begins.

Often yes, on timber and previously painted surfaces, provided the system suits the surface. On old lime-based masonry we use breathable coatings, because sealing a wall can trap moisture.

We can match existing colours from a sample. For original colours, we can help you investigate under later paint layers and then test sample patches on site.

Yes. We repair minor rot and damaged timber and joinery as part of the painting scope, and we say when a carpenter is needed for larger replacement.

Yes. We work in Berrima, Bowral and nearby villages as well as around Wollongong and Kiama.